Mozahn Not all disturbance phenomena have been included for testing purposes in this standard, but only those considered as relevant for the equipment covered by this standard. This third edition cancels and replaces the second edition published inand constitutes a technical revision which includes the following significant technical changes with respect to the previous edition: This standard applies to apparatus intended to be directly connected to a low-voltage public mains network or connected to a dedicated DC source, dei is intended to interface between the apparatus and the low-voltage cfi mains network. These general requirements are in line with for IEDs used in similar environments, for example measuring relays and protection equipment. This standard defines a range of: This fourth edition cancels and replaces the third edition published in and constitutes a technical revision. Characteristics, performance and verification of the test generator and related inductive coils are revised.
|Published (Last):||15 December 2004|
|PDF File Size:||3.68 Mb|
|ePub File Size:||18.29 Mb|
|Price:||Free* [*Free Regsitration Required]|
Akigal Applies to electrical and electronic apparatus intended for use in industrial , as described below. La Norma si occupa dei campi elettromagnetici per frequenze fino a GHz. Such testing is outside the scope of this publication and may not be used to demonstrate compliance with it.
Biodry the Solution Moreover while surge test for ports connected to outside ceo lines was addressed in 6. Gli apparecchi compresi nel campo di applicazione sono: The specifications in this standard apply to EMI receivers and spectrum analyzers. The object of Cie Describes the methods of measurement and specified limits applicable to sound and television receivers and to associated equipment with regard to their immunity characteristics to disturbing signals.
They are in addition to the requirements of the general standard IEC and serve as the basis for particular standards. This edition constitutes the introduction of the RMS-average detector as an alternative to quasi-peak and average detector for conducted and radiated emission measurements. Three locations categories are defined according to their relative position from the building service entrance. Gli aspetti di sicurezza non sono considerati in questa Norma.
Equipment tests made in accordance with this part of IEC are type tests. Eco-Friendly The Biodry technology reverse the current flow which carries the molecules of water up, simply disconnecting the electrical interference on walls.
This part of CISPR 16 is designated a basic standard, which specifies the characteristics and calibration of the absorbing clamp for the measurement of radio disturbance power in the frequency range 30 MHz to 1 GHz. The object of this standard is to define the emission test requirements for apparatus defined in the scope in relation to continuous fei transient, conducted radiated disturbances. Definizioni e campo di applicazione 1. This part of IEC relates to the immunity requirements and test methods for electrical and electronic equipment, under operational conditions, to non-repetitive damped oscillatory transients ring waves occurring in low-voltage power, control and signal lines supplied by public and non-public networks.
As soon as the device will be installed, one of our technician will periodically come to control it to make sure it is correctly functioning. Measurements need only be performed in frequency ranges where limits are specified in —6 6. Specifications for ancillary apparatus are included for artificial mains networks, current and voltage probes and coupling units for current injection on cables.
Other distribution systems are excluded. This new edition eci the following main additions: It includes such equipment as: Also included in the scope of this standard are separate parts of the above mentioned equipment such as motors, and switching devices relays power or protective.
The objective of this standard is to define the immunity test requirements for equipment defined in the scope in relation to continuous and transient, conducted and radiated disturbances including electrostatic discharges. AC or DC supply voltage not exceeding V. This edition constitutes a technical revision which includes the following significant technical changes with respect to the previous edition: A practical basis is provided for the selection of voltage and current tests to be applied in evaluating the surge withstand capability of equipment connected to utility power circuits, primarily in residential, commercial, and light industrial applications.
IN THIS document, guidelines are established for the protec- tion of humans exposed to electric and magnetic fields in the low-frequency range of the electromagnetic spectrum. Test conditions for particular equipment are given in Annex C. In addition, it includes electrostatic discharges which may occur frompersonnel to objects near vital equipment.
La Norma non si applica alle apparecchiature per uso domestico. It establishes a common reference for evaluating the functional immunity of electrical and electronic equipment when subjected to harmonics and inter-harmonics and mains signalling frequencies. For systems with nominal voltages less than V line-to-neutralthe limits have not yet been considered.
It additionally defines ranges of cel levels and establishes test procedures. Therefore, no need to order amendments in addition to this publication. It is applicable to electrical and electronic equipment having an input current equal to or less than 16 A per phase, intended to be connected to public low-voltage distribution systems of between V and V line to neutral at 50 Hz, and subject to conditional connection.
This consolidated version consists of the first edition and its amendment 1 This second edition cancels and replaces the first edition published inand its Amendments 1 and 2 Specifies minimum requirements for emission, immunity and performance criteria regarding electromagnetic compatibility EMC of electrical and electronic equipment for ships.
The publication defines the immunity test requirements for equipment within its scope in relation to continuous and transient conducted and radiated disturbances, including electrostatic discharges ESD. Arc welding equipment which is not professional equipment, with input current up to and including 16 A per phase, is included in this standard. An example of target matching these requirements is also provided; — information on radiated fields from human-metal discharge and from ESD generators is provided; — measurement uncertainty considerations with examples of uncertainty budgets are given too.
These health criteria have provided the scientific database for the subsequent development of exposure limits and codes of practice relating to NIR.
However, no emission requirements apply unless formulated in this standard. TOP Related Articles.
CEI 211-6 PDF
The publication defines the immunity test requirements for equipment within its scope in relation to continuous and transient conducted and radiated disturbances, including electrostatic discharges ESD. However, in the frequency range from kHz up to approximately 10 MHz protection from both, low frequency effects on the nervous system as well as high frequency effects need to be considered depending on exposure conditions. These structures can be further classified as one- two- or multi-port TEM waveguides. GIRDINIO Paola This standard applies to apparatus intended to be directly connected to a low-voltage public mains network or connected to a dedicated DC source which is intended to interface between the apparatus and the low-voltage public mains network.
Misura e valutazione dei campi elettromagnetici per la caratterizzazione dell'esposizione umana
Il corso comprende anche una breve esercitazione pratica di misura di campi elettromagnetici. Scopo Trasferire ai discenti le conoscenze di base per la misura, il calcolo e la valutazione dei campi elettromagnetici, con riferimento particolare alle Guide CEI e CEI RSPP e gli enti suddetti. Programma Ore Analisi dei fenomeni in bassa frequenza Metodologie e strumentazione per la misura dei campi elettrici e magnetici a bassa frequenza; metodologie di calcolo per valutazioni preliminari Descrizione delle principali sorgenti di campo elettrico e magnetico in bassa frequenza impianti elettrici, apparecchiature elettriche ed elettroniche ; riduzione delle emissioni e schermatura Situazione attuale della legislazione e della normativa tecnica in campo nazionale, europeo e internazionale; prospettive di sviluppo futuro Ore Analisi dei fenomeni in alta frequenza Metodologie e strumentazione per la misura dei campi elettrici e magnetici ad alta frequenza; metodologie di calcolo per valutazioni preliminari Ore