Flashes that will support remote flash control through the camera menu. Manual — You must set the manual power level directly on the flash. Type B Cameras — Because Type B cameras do not have a flash control menu for remote control of the flash units, they should always be set to mixed mode so that Manual power levels or FEC can then be set directly on the flashes units themselves. This also sets the camera to HSS by default so that will start as soon as you go over the cameras x-sync shutter speed.

Author:Zuluzuru Zulusho
Language:English (Spanish)
Published (Last):9 October 2017
PDF File Size:17.43 Mb
ePub File Size:13.28 Mb
Price:Free* [*Free Regsitration Required]

Will Lighting Rumours be doing a hands-on review? What is the Yongnuo YNC? It is based on a two-way transmitter-receiver that allows one camera to control multiple flashes at the same time. It runs on 2. TTL, Manual and Multi modes are supported. Where do they fit into the market? However, there are models of the King for Nikon and for Sony.

The YNC is more practical than the RadioPopper PX , which is a bulky hack that only extends the range of an existing infrared system. While the FlexTT5 is much more advanced on paper, some photographers have to put a sock on their flashes for it to work reliably in practice due to radio interference.

This is unlikely to be the case for the 2. How does wireless E-TTL ratio control work? It will behave like an off-camera flash in group A. In the External flash func. The YNC transceivers can actually be set to more channels than the menu supports. To pick channels 5, 6 or 7, select it directly using the buttons on the on-camera YNC transceiver.

Check your camera user manual for more details. How does wireless manual control work? Is it possible to mix wireless manual flash and E-TTL in the same set-up? If you have a flash on-camera, it will be fixed to E-TTL mode.

For your off-camera flashes, set them up individually with their own control panels. Can I use high speed sync? Yes, it is enabled by default. Yongnuo warns that Super Sync results may vary depending on your camera and flash combination. Can I use second curtain sync? Yes, you can select it from the Flash control menu. Can I use high voltage flashes safely? If your flashgun has a high triggering voltage and you connect it to a Yongnuo YNC then you risk damaging the transceiver.

Will there be a YNN for Nikon? Indications suggest it will be a long way off, if the company even decide to make it at all. When will the YNC be available and how much will it cost? With luck, it will be released for export this August. Keep an eye on the official Yongnuo store. Stay tuned!


YONGNUO – YN622C II and YN622N II Announced

The controller also has TTL , manual , and multi flash modes available for full creative control of a flash unit mounted on the YNC Transceiver. Additionally, the system can utilize 7 channels and 3 groups for setting up multiple flash units easily and efficiently. On the device is also an AF assist beam to help in low-light conditions. Multiple sync modes are available for more specific needs or effects, including 1st and 2nd curtain sync. A built-in mini-USB port enables firmware updates to be installed, and the device runs on 2 AA batteries.


Everything you need to know about the Yongnuo YN-622

Well, sort of. Pixel released their King triggers to remove this limit, but their development was truncated. Now we have the Yongnuo YNC which seems to fulfil the promise of a full implementation of Canon flash technologies over a radio link. It seems that Yongnuo has not only achieved this objective, but has added a wide range of triggering and photographer-friendly capabilities. Yongnuo have a range of hot-shoe flashes, with a reputation for unreliability. The design engineer for this device looks like single-handedly rescuing the brand.

Related Articles